PRACTICA 2: Encendido y apagado de los 3 leds de manera intermitente
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.
Most Arduinos have an on-board LED you can control. On the Uno and
Leonardo, it is attached to digital pin 13. If you're unsure what
pin the on-board LED is connected to on your Arduino model, check
the documentation at http://www.arduino.cc
This example code is in the public domain.
modified 8 May 2014
by Scott Fitzgerald
*/
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 13 as an output.
pinMode(13, OUTPUT);
pinMode(12, OUTPUT);
pinMode(11, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(13, HIGH);
delay(5000);
digitalWrite(13, LOW);
digitalWrite(12, HIGH);
delay(5000);
digitalWrite(12, LOW);
digitalWrite(11, HIGH);
delay(5000);
digitalWrite(11, LOW);
delay(5000);
}
Comentarios
Publicar un comentario