PRÁCTICAS ARDUINO

void setup() {   // initialize digital pin 13 as an output.   pinMode(13, OUTPUT);   pinMode(12, OUTPUT);   pinMode(11, OUTPUT);   pinMode(10, OUTPUT); }   void loop() {   digitalWrite(13, HIGH);   delay(100);   digitalWrite(12, HIGH);                digitalWrite(13, LOW);   delay(100);   digitalWrite(11, HIGH);   digitalWrite(12, LOW);   delay(100);   digitalWrite(10, HIGH);   digitalWrite(11, LOW);   delay(100);   digitalWrite(11, HIGH);   digitalWrite(10, LOW);   delay(100);   digitalWrite(12, HIGH);   digitalWrite(11, LOW);   delay(100);   digitalWrite(13, HIGH);   digitalWrite(12, LOW);   } 

 /*   Blink   Turns on an LED on for one second, then off for one second, repeatedly.   Most Arduinos have an on-board LED you can control. On the Uno and   Leonardo, it is attached to digital pin 13. If you're unsure what   pin the on-board LED is connected to on your Arduino model, check   the documentation at http://www.arduino.cc   This example code is in the public domain.   modified 8 May 2014   by Scott Fitzgerald  */ // the setup function runs once when you press reset or power the board void setup() {   // initialize digital pin 13 as an output.   pinMode(13, OUTPUT);   pinMode(12, OUTPUT);   pinMode(11, OUTPUT); } // the loop function runs over and over again forever void loop() {   digitalWrite(13, HIGH);      delay(5000);   digitalWrite(13, LOW);    digitalWrite(12, HIGH);   delay(5000);   digitalWrite(12, LOW);   digitalWrite(11, HIGH);   delay(5000);     digitalWrite(11, LOW);   delay(5000);               }

 /*   Blink   Turns on an LED on for one second, then off for one second, repeatedly.   Most Arduinos have an on-board LED you can control. On the Uno and   Leonardo, it is attached to digital pin 13. If you're unsure what   pin the on-board LED is connected to on your Arduino model, check   the documentation at http://www.arduino.cc   This example code is in the public domain.   modified 8 May 2014   by Scott Fitzgerald  */ // the setup function runs once when you press reset or power the board void setup() {   // initialize digital pin 13 as an output.   pinMode(13, OUTPUT);   pinMode(12, OUTPUT);   pinMode(11, OUTPUT); } // the loop function runs over and over again forever void loop() {   digitalWrite(13, HIGH);   digitalWrite(12, HIGH); // turn the LED on (HIGH is the voltage level)   digitalWrite(11, HIGH);     delay(5000);              // wait for a second     digitalWrite(13, LOW);    // turn the LED off by making the voltage LOW     digitalWrite(12, LOW);     digitalWrite(